Have you ever experienced that you are in a hurry and your car doesn’t get ready to start? No doubt that it is a very common situation and happened a lot. Mean a while you open the hood of the car and look at the battery and see that the corrosion is forming around the tops of the battery terminal connectors on your car.
So, how to clean car battery terminals? Being a car owner, you are responsible for checking the battery regularly. Yes, the clean car battery terminal is important for your car as it helps to perform at its best. If you identify the accumulation of corrosion around the terminals, then you ought to remove this car battery corrosion immediately otherwise it spoils your battery with overtime. According to Tips4car.com, whenever you see this white powdery substance “corrosion” around the battery terminal, you ought to clean car battery corrosion as soon.
How to Clean Car Battery Terminals – Clean Car Battery Corrosion (DIY)
Well – You can easily clean the car battery terminal through these tested steps. Give a read to this article and clean the corroded car battery terminals immediately:
Locate The Car Battery:
Before starting the cleaning process, you ought to locate the battery. Yes, most of the batteries are located underneath the hood, and some are found on the left or right side of the engine bay. There are only a few models in which the battery is placed in the trunk.
Lift The Covers of Car Battery Terminals:
You ought to lift the plastic or rubber covers to access the clamps that are being connected with the cables to the battery terminals. Before cleaning the corrosion don’t forget to put on a pair of work gloves and should wear safety glasses.
Begin With Disconnecting The Car Battery:
The most important factor of cleaning is to disconnect your car battery. You will do this by loosening the negative (-) clamp first, then remove the positive (+) ones. If you see the excess corrosion present on the terminals, then you need to use metal pliers to disconnect.
Note: You should remove the negative (-) clamp before (+) one.
Make Your Cleaning Agent:
When it comes to cleaning car battery corrosion, then you have a choice of two cleaning agents. The first one is baking soda – Yes, take 2 tbsp of baking soda and an equal amount of water into a clean container and mix both very well to make a thick paste. Apply this paste to the terminal with the help of a toothbrush. After that, you will see the bubbles as a result of soda reactions to corrosions. Once done, you can take a wire brush to remove the remaining residue.
The second one is Coca-cola – it is the easiest and effective way, you can pour a little amount of cola on terminals and begin scrubbing them with the help of wire brush. The advantage is that there is no need to make a paste-like baking soda. You remove the corrosions with the help of wire brush, if necessary.
Rinse and Dry The Terminals:
Now, it’s time to remove the paste or soda to finish the process of cleaning. Take a bottle of water; begin washing each terminal with the water to remove the dregs. Once done, take a rag and use it to dry each terminal of the battery. Finally, slather a dab of petroleum oil on each terminal as it prevents future corrosion.
Reconnect The Clamps of Battery:
Ultimately – you need to take back the clamps of the battery. First, put the positive (+) clamp and then put the negative (-) clamp. Take a wrench to tighten the clamps, if required. Finally, place the rubber or plastic covers over each terminal. Yes, you have done a great job, your battery is cleaned and ready to use, put your tools, cleaning agents and gloves away.
Surprisingly – you unfold the question of how to clean car battery terminals. You can easily clean battery terminals and remove all the corrosions or residue with the help of the above ways. If your car battery terminals are cover up with corrosion, then stop worrying more! Follow the above steps and get effective and instant solution.